The Presscontrol is an professional electronic automatic controller ideal for controlling and protection of single phase pumps. The controller is designed to start and stop the pump depending on opening and closing of the taps. It will also protect the pump in case of a water shortage by preventing it from dry running. Press controllers are ideal for above ground and submersible pumps.

Features.

• Run Dry Protection
• Colour: Blue/Yellow
• 1.5 or 2.2 Bar Cut In
• A user-friendly interface with LED indicators displaying power status, pump running and alarm indication
• Wetted parts are made from high quality corrosion resistant materials
• 1” BSP (25mm) Inlet/Outlet 

Technical Features.

• Power: 1.5kW (2 HP)
• Max Current: 10A
• Max Operating Pressure: 12 Bar
• Single Phase-230
• Frequency: 50-60 Hz
• Protection Grade: IP65
• Tax Temperature: 60°C
• Minimum Flow Rate - 1 LPM

Installation & Start up. 

The device can be installed directly on the pump or between the pump and the first tap. Make all the electrical connections, check that the pump is correctly primed, open a tap and energize. The green Power on Led will light up on the control panel and the pump will start (yellow “Pump on” Led on) and will keep running for several seconds to pressurize the system.

If this time is insufficient, the device will stop the pump (red “Failure” led on). Press and hold down the Restart button until the red Failure led turns off and the water comes out of the open tap. When the tap is closed, the pump will stop after a few seconds (yellow “Pump on” led turns off).

Once installed, the device will turn the pump on and off depending on the opening and closing of the tap. In case of water shortage, the device will stop the pump and protect it from dry running (red “Failure” led on). In case of a temporary blackout, the device will automatically rearm once the electricity returns

Click here for more information.